Tag Archives: glock recoil

Seems like everyone has a new .22LR pistol for 2020

Only a few weeks into 2020 and the domestic U.S. firearms market has seen a flood of new .22LR pistols from some of the biggest names in the business.

Last month saw the 42nd annual SHOT Show in Las Vegas where more than 2,600 exhibitors gathered from around the globe to display their freshest wares. When it came to rimfire handguns, there were lots of new faces in the aisles.

More in my column at Guns.com. 

Glock’s new pistol turned out to be a super reliable plinker

When it comes to .22LR, the biggest problem is the round itself.

First marketed in 1884 as a black powder round, the little lead-nosed pipsqueak was intended for use in rifles and revolvers, with its rimmed case proving notoriously difficult for pistols to cycle. Compounding this, there is a myriad of loads in circulation, all with slightly different specs and performance. When you magnify those problems with the fact that the rounds are often produced by the millions as economically as possible, especially in the case of bulk-pack budget ammo, and you get a cartridge that tends to be finicky in a lot of semi-auto handguns.

To get it right, Glock spent nearly three years testing and developing the G44– which is why models like the G45, G46, G47, and G48 passed it up in reaching the market while the rimfire chewer was still in R&D.

During that time, they used no less than 141 different rimfire loads in testing, popping over 1.2 million rounds in the process. Federal, which supported the effort, used everything in test guns from 42-grain subsonic to CCI Stingers with no problem. In short, while many 22LR pistols come with the caveat that they are picky about their diet, the Glock is billed as being omnivorous.

Well, I grabbed 2,200 rounds of a wide array of .22LR and headed to the range with a new G44 sent for T&E.

How did it do?

More in my column at Guns.com. 

The ticking time bomb that is the recoil spring

It is hard to beat a Glock of any generation when it comes to reliability, but it comes as a shock to many that inside their slide hides a pitfall to the whole program that the savvy polymer pistol user can easily overcome.

Like a 5,000 round failure point…

One of these things are not like the other– but both need to be evaluated at/near the 5K mark! Here we see a Gen 3 Glock 19 factory recoil spring assembly compared to one for a gen 4 Glock 22

The standard Glock factory guide rods are (this should come as no surprise to you) made from polymer. While low-cost and easy to produce, these plastic guide rods can chip, crack or break resulting in feeding or ejection failures. Further, these guide rods flex to a degree when in operation, which many argue will contribute to accuracy problems due to poor consistency. Finally, they have been known to snap, leaving the pistol inoperable. This weak link can be alleviated by putting some heavy metal into the mix.

More in my column at Tac.44.com